Tutorial to Root AT&T Powered Samsung Galaxy Note N7000B

Sanjana February 21, 2012 0

Samsung Galaxy Note gets rooted just hours after it started rolling out via AT & T. It is to be noted that rooting will void the device’s warranty and the only way to reclaim back the warranty is by re-applying the default or official firmware in your device.

galaxy note

We wont be responsible for any harm caused to your device during the rooting procedure that is unlikely to happen if you follow the instructions carefully. The rooting procedure is not recommended for basic users but is for advanced users and is only applicable for Samsung Galaxy Note N7000 that are network unlocked. Do not apply it in any other device as it might not be reversible and may harm the device by blocking it.

Pre-Requisites:

You must backup all the user data present in your device since chances of data loss or corruption are there. Having a backup will help you replace the lost data if any damage occurs. Follow the link posted below to  backup and restore all your data easily.

Pre Upgrade Instructions for Rooting and Firmware Update

Must Have:

Download USB Drivers PackageDownload Rooting TAR fileDownload Odin

Steps to Root AT&T Powered Samsung Galaxy Note:

Step-1: Download all the tools mentioned in the Must Have section  and extract it to your computer. After extraction is over, open Odin and power off your device to enter into Download mode. The Download mode can be entered by pressing Volume Down keyOK button and holding both, simultaneously press Power button. If the device boots into Normal mode then re-try to enter into Download Mode by the same process till you are finally there.

root note


Step-2: Once you enter into download mode connect your phone to the computer via USB Cable while keeping the ODIN opened. Now the drivers will get installed and ID: COM will turn yellow indicating that you can now proceed to the next step.

root note

Step-3: In Odin, tap on PDA and choose the file named as “pda.tar” from the extracted folder. Now tap on “Start” to begin the firmware updation process. After the firmware is successfully applied, it will restart on its own. In case the device gets stuck in the middle, then you have to re-apply the entire procedure again from the beginning.

root note

Step-4: Now disconnect the USB cable and power off the phone to enter into Recovery mode. The Recovery mode can be entered by by pressing Volume Up Key + OK button and holding both press Power button simultaneously. In Recovery mode, select “Wipe data/factory reset” > “Wipe Cache partition” > “Clear Dalvik Cache” then reboot your device by selecting the option of “Reboot system now”.

Step-5: To confirm whether the firmware has been successfully applied or not navigate to the path “Settings > About Phone > Firmware Version” where it will display the current firmware as XXLA3 Android 4.0.3 version. If any other version is being displayed then apply the process again from the beginning. If the process gets stuck somewhere in the middle then, pull out the battery, re-insert it and re-apply the instructions again from the beginning.

Thus you can easily root your Samsung Galaxy Note N7000 by following the steps mentioned above carefully.

Leave A Response »